Old Army/Navy Revolver Cases

 Old English-style case with partitioned compartments for gun, flask, bullets and mold. Designed to fit most old model 1849 Pocket model as well as the1851 through 1861 Army/Navy revolvers, with a separate compartment for a bullet mold (not shown).

Each case is built out of solid black walnut, has rounded edges, offset joints and 2 snap catches and is finished with a clear satin lacquer finish.  Green, red or blue felt is available.

 *Barrel length is measured from the muzzle to the front of the cylinder.

*The Deluxe case (shown in the LEFT picture) has a lid on the corner compartment and a black scuff pad on the outside bottom of the case to protect any surface the case is set on.

Sizes available:

*For 1849 Pocket Model, with 5" barrel- Pocket model cases are in the deluxe fitting only.  No separate compartment for the flask and mold.

GWB11-D Outside dimensions: 11"L x 5 1/2"D x 2 1/4"H Inside dimensions: 10 1/4"Lx4 3/4"Dx1 7/8"H

*For 1851 & COLT 1861 Colt Navy revolvers, with 6 1/2" through 7 1/2" barrels

GWB1412 Outside dimensions:14 1/2"Lx6 1/4"Dx2 1/4"H Inside dimensions: 13 3/4"Lx5 1/2"Dx1 7/8"H

 *For 1858 Remington New Army revolvers with 8" barrel

GWB15 Outside dimensions: 15"L x 6 1/4"D x 2 1/4"H Inside dimensions: 14 1/4"L x5 1/2"D x 1 7/8"H

*For 1860 Colt Army revolvers with 8" & 9" barrels

GWB16 Outside dimensions: 16"L x 6 3/4"D x 2 1/4"H Inside dimensions: 15 1/4"L x 6"D x 1 7/8"H